Month: March 2019

Portable with Essex Ham

The weather looked reasonable, so @essexham suggested it would make a nice afternoon for a ham based meet up at Gallywood Chelmsford.

Essex Ham is a virtual club, great for like minded local hams to meet up and experiment. I opted for my usual setup, 12m fibreglass pole and a 4m slim jim antenna.

The slim jim is a tried and tested design, and made from 300 ohm ribbon feeder, although other designs are available. The antenna can be rolled up and easily transported to site.

Portable Equipment

50 Ah Portable 12v battery

Icom 7300 and 12 m Push up pole and Slim Jim antenna

It was interesting to work G1NOX Mel in Dartford, M6OVN/P Glyn near Winchester, M1ECC Dave in Basildon, M0FAQ Martin in Great Notley and G7UTB Jim in Rochester.

Glyn M6OVN/P was 72 miles away, not a bad VHF contact.

Various poles with people trying out different antenna configurations.

MF and HF RX Antenna Splitter

I was looking for a simple project to split a RX antenna into two receivers, my Wellbrook loop feeds my Kiwi SDR and also my HF radio.

The Wellbrook loop is very capable at LF and MF frequencies, and so makes a great alternative for RX on 472 KHz and even NBD reception should my local noise allow.

The RX slitter was originally found as a PDF credited to Todd VE7BPO, but had later been refined by Dave G4AON. The project uses 2x FT50-43 ferrite torroid and 100 Ohm resistor to match the output to 50 Ohms.

The addition of 3 x SO239 sockets (or sockets of your choice) and a suitable box will see the project come in around £5. Unlike some of the cheap CB style splitters, this will be 50 Ohm matched.

Thanks to George M1GEO for helping with the construction.