QRO portable from Cromer North Norfolk

I have always enjoyed operating portable HF as you can put up antenna and work bands not possible at home. This coupled with finding an RF quiet location can make HF portable very enjoyable.

Using a 12m spider beam roach pole, an 80m doublet fed with 300 Ohm ribbon cable and Icom 7100 I parked in a rural country lane surrounded by fields. The doublet was cable tied to the roach pole at around 11m, and the pole secured to a farmers fence.

 

 

The Icom, Expert 1.3KFA linear and ATU was placed in the boot of the car, and power was provided by an EU20 Honda generator. I started operating at 19:26 with the first call in the log G4JXC Bob from Bristol, signals seemed very good with reports usually over s9, sometimes s9+40.

At times I had a pile-up, really hard to pick out any calls, I did try and pull out a few QRP stations some running just 3 and 4w.

The amplifier definitely helped, but getting a large antenna in the air inverted V means a lot of the RF goes up in the air. Over the next couple of hours, I worked 57 stations in 10 countries. As darkness descended the skip did lengthen out a little, with stations calling me from Sweden, Germany, Spain and the Netherlands.

 

I was also able to monitor my own signal on my KiwiSDR located some 100 miles away. It was fun to work some stations that had also used my SDR, and also catch up with some people on twitter.

 

A enjoyable was to spend an evening, thanks to everyone who called.

 

2 Comments

Add a Comment
  1. Good to talk to you this evening Dave. 7100 and the expert amp working well well 🙂 Loving the short stub coax to the balun. 73 Richie – MW0LGE

    1. Thanks, Richie, nice to work you this evening. Had some great fun on the bands, hope to catch you again soon 73 Dave

Leave a Reply to Richie Cancel reply

Your email address will not be published.

7 + 2 =

This site uses Akismet to reduce spam. Learn how your comment data is processed.